beautypg.com

Operation – CHAMPION UL-130 Manual User Manual

Page 27

background image

17

Models UH130, UH130B - Operation

Operation -

Models UH130, UH130B Only

Wash Temperature

Digital Display

Final Rinse Temperature

Digital Display

Prime

Push button

In-cycle Light

Start

Push button

ON-OFF/DRAIN

Power Switch

UH130B Control Panel

WASH

RINSE

PRIME

DETERGENT

RINSE AID

OFF/DRAIN

ON

POWER

START

TEMPERATURE

1 8 0

1 5 0

1. Close the dishwasher front door.
2. Push the dishwasher Power Switch UP to turn the power ON.
3. The power switch will illuminate and the machine will fill with water.
4. Wait until the wash temperature gauge indicates a minimum of 150ºF/66ºC.

RUN THE FIRST CYCLE EMPTY TO HEAT THE WASH TANK INTERIOR.

5. Load the dish rack into the machine. Wash one dish rack at a time.
6. Close the door, then press the START BUTTON for 1 second. The green in-cycle

light will illuminate and the wash cycle will begin. The total cycle is approximately

141 seconds.

7. Opening the door during a cycle will stop the dishwasher. The cycle will resume

automatically when the dishwasher door is closed.

8. The final rinse cycle begins at the end of the wash cycle. The machine drains and then

refills with fresh water hot water. Check the rinse temperature gauge during the final rinse.

It must indicate a minimum of 180-195ºF/82-91ºC. The final rinse water is retained

for the next wash cycle.

9. When the green cycle light goes out, open the door and remove the rack of clean wares.

Normal Wash Mode

! ATTENTION !

DOOR LEFT OPEN DURING WASH CYCLE

If the dishwasher door is left open for more than 5 seconds during the normal wash mode, then

the dishwasher cycle will reset to the beginning of the normal wash cycle.

! ATTENTION !

RINSE SENTRY MODE WILL EXTEND WASH CYCLE TIME

In the event that the final rinse temperature has not reached 180-195ºF/82-91ºC after the

wash cycle, the rinse sentry will extend the wash cycle time until the booster reaches

180-195ºF/82-91ºC. If the proper temperature is not reached within 5 minutes, the machine

will leave the rinse sentry mode and complete the cycle.

This manual is related to the following products: