CHAMPION UL-130 Manual - Manual (Page 32)

22
Cleaning - Models UH130, UH130B, UH230, UH230B -
Cleaning the wash arms:
Cleaning - Models UH130, UH130B and UH230, UH230B
1. There are two wash arms in the UH130,
UH130B, the UH230 and UH230B.
They are interchangeable.
2. The UH130, UH130B wash arms are
combination wash/rinse arms. The UH230,
UH230B are wash arms only.
3. The wash arms should be removed and
thoroughly flushed clean in a sink.
4. Special attention should be paid to the
cleaning and inspection of the wash arm
bearings making sure they are clean and
free of excessive wear.
5. If the bearings are damaged, contact an
authorized service agent for replacement.
Model UH230B Only
Disassemble the rinse arm assembly.
Models UH130B and UH230B
Clean the upper and lower wash arm bearings.
1. There are two rinse arms in the UH230, and
UH230B. They are interchangeable.
2. Special attention should be paid to the
cleaning and inspection of the rinse arm
bearings making sure they are clean and
free of excessive wear.
3. If the bearings are damaged, contact an
authorized service agent for replacement.
4. The rinse arm spray nozzles should be
inspected and if necessary, cleaned with
a small paper clip or wire.
5. The rinse arm pipes can be flushed out by
removing the pipe end plugs with a flat
blade screw driver.
Cleaning the rinse arms
(UH230, UH230B Only):
Model UH230B Only
Clean the upper and lower rinse arm bearings.
Model UH230B Only
Rinse arm nozzles and end plugs are located on
the rinse arm pipes.