Auto Meter 6002 - Manual (Page 8)

Chapter 1. Introducing the Display Systems
2 Street Dash Users Guide
When the warning condition alarm light is switched on, a
warning message is shown on the digital display to identify the
condition. You can enable or disable the warning system for each
parameter individually.
You can cancel the warning message by pressing Switch 2 or 3.
Doing this does not turn off the warning condition alarm light,
which stays on until the condition no longer applies.
You can redefine the preset alarm values for each parameter to
those which are more suitable for your vehicle.
The system provides outputs for two external warning lights:
• a gear shift warning light that is based on an RPM value
that you define for your vehicle
• an additional alarm warning light for the alarms described
on previous page
The Street Dash Display can also be fitted with an optional lap
timing sensor and fuel pressure sensor.
Speed Sensor
This system obtains the vehicle’s speed from pulses generated by
the VSS (vehicle speed sensor) located in the transmission, on
the driveshaft, or from a wheel speed sensor.