Switching alarms on or off – Auto Meter 6002 User Manual
Page 23
Chapter 4. Configuring the Display System
Street Dash Users Guide
17
Switching Alarms on or off
You can enable (switch on) or disable (switch off) each of the
alarm warnings by pressing and holding Switch 1 and then
pressing Switch 2.
Note that you might change the preset value of the parameter
slightly while pressing both switches. This does not matter if you
are switching the alarm warning off and, if necessary, you can
correct the preset value after you switch it on again.
Summary of Configuration Switches
This manual is related to the following products:
See also other documents in the category Auto Meter For the car:
- 1299 (2 pages)
- 1289 (3 pages)
- 1295 (3 pages)
- 1298 (2 pages)
- 1225 (2 pages)
- 1294 (2 pages)
- 1256 (1 page)
- 1209 (2 pages)
- 1258 (1 page)
- 1282 (1 page)
- 1253 (2 pages)
- 1185 (1 page)
- 1349 (2 pages)
- 1388-M (2 pages)
- 1390 (2 pages)
- 1308 (2 pages)
- 1303 (2 pages)
- 1302 (2 pages)
- 1396 (1 page)
- 1397 (2 pages)
- 1399 (2 pages)
- 1300 (1 page)
- 1398 (2 pages)
- 1332 (4 pages)
- 1315 (2 pages)
- 1385 (1 page)
- 1898 (2 pages)
- 1109 (2 pages)
- 201008 (2 pages)
- 201004 (2 pages)
- 6290 (2 pages)
- 6299 (3 pages)
- 6390 (2 pages)
- 6180 (4 pages)
- 6178 (6 pages)
- 6150 (7 pages)
- 6175 (4 pages)
- 6187 (2 pages)
- 6188 (4 pages)
- 6181 (7 pages)
- 6144 (2 pages)
- 7961 (2 pages)
- 6171 (2 pages)
- 7956 (2 pages)
- 6193 (2 pages)