AirLive WN-300ARM-VPN - Manual (Page 87)

screen.
This screen allows you to view details of each current VPN Tunnel (connection). If there are no current
connections, the status table will be empty.
Figure: VPN-Status Screen
-3- Data - VPN Status Screen
Tunnel Table
This table contains the following data about each current connection.
 Policy Name - The name of the policy. When a policy is created, it must
be given a unique name to identify it.
 Remote Endpoint - The address of the remote VPN endpoint.
 SPI (In) - This is a unique index number to identify the incoming
connection. For "Auto" policies, the SPI is automatically generated. For
"Manual" policies, the SPI must be entered when the policy is configured.
 SPI (Out) - This is a unique index number to identify the outgoing
connection. For "Auto" policies, the SPI is automatically generated. For
"Manual" policies, the SPI must be entered when the policy is configured.
 Action - This column will contain a button which allows you to break
(terminate) the current the VPN connection.
Buttons
Auto Refresh
Use this to Enable or Disable auto-refresh for this screen. If enabled, the
screen will be updated every few seconds.
The status bar on the bottom on the screen will indicate if auto-refresh is
enabled or disabled.
VPN Log Click this button to switch to the VPN log screen.
The VPN log shows details of each connection as it is created.
AirLive WN-300ARM-VPN User’s Manual 85