AirLive WN-300ARM-VPN User Manual
Page 10
AirLive WN-300ARM-VPN User’s Manual
8
VPN Features
IPSec Support. IPSec is the most common protocol.
Easy Configuration. The configuration required to allow 2 Wireless ADSL Routers to establish a
VPN connection between them is easy accomplished.
IPSec VPN Tunnels. WN-300ARM-VPN supports to be created up to 5 IPSec tunnels.
Wireless Features
Standards Compliant. The WN-300ARM-VPN complies with the IEEE 802.11g (DSSS)
specifications for Wireless LANs.
Supports Pre-N Wireless Stations. The 802.11n Draft standard provides for backward
compatibility with the 802.11b standard, so 802.11n, 802.11b and 802.11g Wireless stations can be
used simultaneously.
WEP support. Support for WEP (Wired Equivalent Privacy) is included. Key sizes of 64 Bit and 128
Bit are supported. WEP encrypts any data before transmission, providing protection against
snoopers.
WPA-PSK support. Like WEP, WPA-PSK encrypts any data before transmission, providing
protection against snoopers. The WPA-PSK is a later standard than WEP, and provides both easier
configuration and greater security than WEP.
WPA2-PSK support. Support for WPA2 is also included. WPA2 uses the extremely secure AES
encryption method.
802.1x Support. Support for 802.1x mode is included, providing for the industrial-strength wireless
security of 802.1x authentication and authorization.
Wireless MAC Access Control. The Wireless Access Control feature can check the MAC address
(hardware address) of Wireless stations to ensure that only trusted Wireless Stations can access
your LAN.
Simple Configuration. If the default settings are unsuitable, they can be changed quickly and
easily.
WPS Support. WPS (Wi-Fi Protected Setup) can simplify the process of connecting any device to
the wireless network by using the push button configuration (PBC) on the Wireless Access Point, or
entering a PIN code if there's no button.
WDS Support. Support for WDS (Wireless Distribution System) allows the Wireless Access Point
to act as a Wireless Bridge. Both Point-to-Point and Multi-Point Bridge modes are supported.