beautypg.com

2 lan screen, Lan screen – AirLive WN-300ARM-VPN User Manual

Page 24

background image

3.2 LAN Screen

Use the LAN link on the main menu to reach the LAN screen. An example screen is shown below.

Figure 1: LAN Screen

-1-

Data - LAN Screen

TCP/IP

IP Address

IP address for the WN-300ARM-VPN, as seen from the local LAN. Use the

default value unless the address is already in use or your LAN is using a

different IP address range. In the latter case, enter an unused IP Address from

within the range used by your LAN.

Subnet

Mask

The default value 255.255.255.0 is standard for small (class "C") networks. For

other networks, use the Subnet Mask for the LAN segment to which the

WN-300ARM-VPN is attached (the same value as the PCs on that LAN

segment).

DHCP

Server

 If Enabled, the WN-300ARM-VPN will allocate IP Addresses to PCs (DHCP

clients) on your LAN when they start up. The default (and recommended)

value is Enabled.

 If you are already using a DHCP Server, this setting must be Disabled, and

the existing DHCP server must be re-configured to treat the

WN-300ARM-VPN as the default Gateway. See the following section for

further details.

 The

Start IP Address and Finish IP Address fields set the values used by

the DHCP server when allocating IP Addresses to DHCP clients. This

range also determines the number of DHCP clients supported. Enter the

desired value for the Lease Time, which should be between 1 and 7.

See the following section for further details on using DHCP.

AirLive WN-300ARM-VPN User’s Manual

22