AirLive WN-300ARM-VPN User Manual
Page 86
AirLive WN-300ARM-VPN User’s Manual
84
Local Identity
Type
Select the desired option to match the "Remote Identity Type" setting on
the remote VPN endpoint.
WAN IP Address - your Internet IP address.
Fully Qualified Domain Name - your domain name.
Fully Qualified User Name - your name, E-mail address, or other ID.
Local Identity
Data
Enter the data for the selection above. (If "IP Address" is selected, no input
is required.)
Remote Identity
Type
Select the desired option to match the "Local Identity Type" setting on the
remote VPN endpoint.
IP Address - The Internet IP address of the remote VPN endpoint.
Fully Qualified Domain Name - the Domain name of the remote VPN
endpoint.
Fully Qualified User Name - the name, E-mail address, or other ID of
the remote VPN endpoint.
Remote Identity
Data
Enter the data for the selection above. (If "IP Address" is selected, no input
is required.)
SA Parameters
Encryption
Encryption Algorithm used for both IKE and IPSec. This setting must match
the setting used on the remote VPN Gateway.
Authentication
Authentication Algorithm used for both IKE and IPSec. This setting must
match the setting used on the remote VPN Gateway.
Pre-shared Key
The key must be entered both here and on the remote VPN Gateway. This
method does not require using a CA (Certificate Authority).
SA Life Time
This determines the time interval before the SA (Security Association)
expires. (It will automatically be re-established if necessary.) While using a
short time period (or data amount) increases security, it also degrades
performance. It is common to use periods over an hour (3600 seconds) for
the SA Life Time. This setting applies to both IKE and IPSec SAs.
IPSec PFS
(Perfect Forward
Secrecy)
If enabled, security is enhanced by ensuring that the key is changed at
regular intervals. Also, even if one key is broken, subsequent keys are no
easier to break. (Each key has no relationship to the previous key.)
This setting applies to both IKE and IPSec SAs. When configuring the
remote endpoint to match this setting, you may have to specify the "Key
Group" used. For this device, the "Key Group" is the same as the "DH
Group" setting in the IKE section.
VPN Auto Policies Screen
This screen is displayed when you click the VPN Log button on the VPN Policies screen, or on the Status