2N 4G wireless router 2N SpeedRoute - User manual, 1898 v1.02 - Manual (Page 97)

Troubleshooting 6.2
97
6.2 Troubleshooting
For tips for the solution of other potential problems see faq.2n.cz.
´
No LED is on after power up.
u Check the power supply.
´
2N ® SpeedRoute is not logging into the GSM network.
u Check the SIM card.
u Check the PIN.
u Check the antenna connection.
u Select a place with a good GSM signal.
´
The 2N ® SpeedRoute Internet connection has not been established.
u Check the setting of the APN assigned to the SIM card by the provider.
´
No tone can be heard after line off-hook.
u Check the telephone line connection.
u 2N ® SpeedRoute has not been initialized properly (approx. 10 s after
power up).
u 2N ® SpeedRoute is not supplied with power.
´
2N ® SpeedRoute is ignoring the user dialling, transmitting the dialtone.
u Select the correct dialling type (DTMF/pulse).
u Adjust the width of the dialling pulses.
u Adjust the delay value between the pulses.
´
2N ® SpeedRoute is not communicating with the PC.
u Check the Ethernet cable connection.
´
Do you need to set some functions 2N ® SpeedRoute?
u Try to find help on HOW TO manuals. Current and new manuals can
always be found on www.2n.cz