Table of programmable parameters 3.2 – 2N 4G wireless router 2N SpeedRoute - User manual, 1898 v1.02 User Manual

Page 45

Table of Programmable Parameters

3.2

Allow

Use this parameter to allow/bar calls with the prefixes specified on the given row.

VoIP

LTE3

Only in fax version of 2N

EasyRoute. Use this parameter to redirect calls with the

prefixes specified on the given row to VoIP network.

Length

Use the Length parameter to define the expected length of a number including its

prefix for the given row. This enables the start of a GSM dialling immediately after

the last digit is dialled. If the telephone number to be dialled is shorter, the call

will not be set up until the predefined timeout elapses. ‘0’ means that the function

is disabled.

Setting options:

0-20

Use the # parameter to enable call set-up whenever a ‘#’ (hash) is received. This

character is removed from the number to be dialled. If you want the ‘#’ to be part

of the dialled number, you cannot use this function for the given prefix.

Remove

Use the Remove parameter to enable automatic call forwarding. Define a number

of digits (prefix) to be removed from the beginning of the number to be dialled.

Setting options:

0–20

Add

Use the Add parameter to enable automatic call forwarding. Define a string

(prefix) to be added to the beginning of the number to be dialled.

Setting options:

0–8 characters (0–9, *, #, +)

Extra

Set the pseudo tariff metering rules independent of call duration. Set a fixed count

of tariff pulses to be added to the pulses sent according to the call duration and

the Tariff rate setting after the call start. This parameter helps set the minimum

call cost.

Setting options:

0–255

Setting step:

Default setting:

Tariff

Set the pseudo tariff-metering rules based on call duration. Define how often (in

seconds) you want to transmit tariff pulses. A lower number means a more

expensive call. ‘0’ means no tariff pulse metering according to call duration.

Setting options:

0–255 s

Setting step:

1 s

Default setting:

0 s

Tip

Refer to S. 4 of this User Manual for table setting examples.