2N 4G wireless router 2N SpeedRoute - User manual, 1898 v1.02 - Manual (Page 64)

Table of Programmable Parameters 3.2
64
Enable
Enables to use protocol SNMP.
Notification Enable
Enables SNMP trap sending.
Network interface
This setting is used to select which interfaces will be used for SNMP trap sending
and which interface will be open for SNMP requests.
Setting options: All – all accessible interfaces permitted.
LAN
WAN
Note
n Following parameters are used for device specification. It is not necessary
to fill it, the device can present yourself by its serial number. For better
communication with control center is better to use these parameters.
n When are these fields filled, parameters will be added into data packets
with send information.
System name
The name is used for simple identification of the device. Default setting is
‘SpeedRoute’.
System Contact
Parameter for contact information (E-mail or phone number) of device admin.
System Location
More detail information of any kind, information about installation, street address,
GPS location etc.