2N 4G wireless router 2N SpeedRoute - User manual, 1898 v1.02 - Manual (Page 82)

82
5. When the called subscriber answers the call, a call is established. The Line
LED is permanently on during the call.
6. Hang up to terminate the call. The Line LED goes off. If the called subscriber
is the first to hang up, you will hear the busy tone and you have to hang up.
Incoming Call
1. Ringing signals an incoming call. The Line LED keeps flashing during ringing.
If programmed so, 2N ® SpeedRoute transmits the FSK-based CLIP between
the first and second rings. Advanced telephone sets are able to display the
CLI.
2. Hook off the phone to establish the call. The ‘Line’ LED is permanently on
during the call.
3. Hang up to terminate the call. The ‘Line’ LED goes off. If the called subscriber
is the first to hang up, you will hear the busy tone and you have to hang up.
Automatic Call (BabyCall)
If the Automatic Call (BabyCall) function is enabled, a pre-programmed period of time
is counted down after off-hook. If you do not start dialling within this timeout,
2N ® SpeedRoute signals dialling end and starts establishing a call to the pre-
programmed number automatically – from now on 2N ® SpeedRoute behaves as if
processing a standard outgoing call. Any dialling during the BabyCall timeout cancels
this function and a standard outgoing call can be made.
16 or 12 kHz Tariff Pulses
2N ® SpeedRoute has a tariff pulse transmitter. You can use the pulses for outgoing
call metering and/or billing. 2N ® SpeedRoute offers pseudo tariff metering only – its
tariff pulses do not correspond to the provider’s call tariffs but are transmitted
according to the pre-programmed parameters. Remember to program the routing
table parameters in order to set tariff metering for calls with different prefixes.
You can also program 2N
® SpeedRoute to transmit tariff pulses as call
connect/disconnect signalling if your PBX cannot receive telephone line polarity
reversal signalling.
n Ethernet Switch and WiFi Interface
n SIM Card PIN Protection