2N 4G wireless router 2N SpeedRoute - User manual, 1898 v1.02 - Manual (Page 39)

Table of Programmable Parameters 3.2
39
SLIC > Signalling
Pulse frequency
Set the tariff pulse frequency.
Setting options: 12/16 kHz
Tariff pulse when call starts
Enable/disable tariff pulse sending when the call begins. The pulse is sent when
the call is answered in the GSM network.
Tariff pulse when call ends
Enable/disable tariff pulse sending when the call ends. The pulse is sent when the
call is hung up in the GSM network.
SLIC > Advanced
Receive Path High Pass Filter
Enable/disable the high pass filter for the signal receive path.
Transmit path high pass filter
Enable/disable the high pass filter for the signal transmit path.
Receive Path Gain
Set the gain for the receive path.
Setting options: 0 dB
3.5 dB
-3.5 dB
Muted
Transmit Path Gain
Set the gain for the transmit path.
Setting options: 0 dB
3.5 dB
-3.5 dB
Muted
Line Capacitance Compensation
Set the line capacitance compensation.
Setting options: Off
4.7 nF
10 nF
Two-wire Impedance Synthesis
Adjust the telephone line to the FXS interface.
Setting options: 600 Ohm
900 Ohm
600 Ohm + 2.16 µF
900 Ohm + 2.16 µF