2N 4G wireless router 2N SpeedRoute - User manual, 1898 v1.02 - Manual (Page 51)

Table of Programmable Parameters 3.2
51
WAN
Mode
Used for enabling the WAN port function on your gateway. If you enable the WAN
port, LAN1 is converted into WAN. There are three setting options:
· Off – disable the WAN function.
· Static – enable the WAN function. Set the fixed WAN IP address.
Useful especially when you use the cable or WiFi connection and know
the IP address assigned to you.
· Dynamic – enable the function to get setting from DHCP server. All
settings for network interface are received from DHCP server located in
connected network.
· PPPoE – enable the WAN function. Enter the login data to your
provider. Used mainly for the ADSL connection where you are assigned
the IP address by the provider after login authentication.
Caution
n Important! The static IP and PPPoE cannot be used at the same time.
Even if both the options are selected and saved in the database, the
option that is programmed is applied.
Static