2N 4G wireless router 2N SpeedRoute - User manual, 1898 v1.02 - Manual (Page 44)

Table of Programmable Parameters 3.2
44
automatically. If any digit is dialled, the Automatic call (also referred to as
BabyCall) function is cancelled.
Enable
Here enable/disable the Automatic Call function.
Number
Here enter the number to be used for the Automatic Call.
Setting options: 0–31 characters (0–9, *, #, +)
Timeout
Set the time interval between the line off-hook and the beginning of the Automatic
Call (if enabled). During this timeout, 2N ® EasyRoute waits for a dialling to cancel
the Automatic Call. Thus, you can make standard calls even if the BabyCall
function is enabled.
Routing
Routing mode
The lower screen menu helps you set the mode of the routing table use.
Setting options:
All to GSM: 2N ® EasyRoute routes all calls to the GSM network regardless of
the routing table settings. Available for HSPA+ version only (LTE3)
All to VOIP: 2N ® EasyRoute routes all calls to the VoIP network regardless of
the routing table settings.
Use table: 2N ® EasyRoute routes all calls to the GSM or VoIP network
according to the routing table settings. For LTE version (LTE2) all
calls routed to VoIP, the table can be used for other parameters
setting.
Prefix
Enter the call type identifying prefixes (GSM, trunk, free, etc.). The Others row is
used for calls with prefixes that are not included in the table. One empty row is
always available. When a prefix is entered and saved, another empty row is
added. To remove a row, delete the prefix and save the data again.
Setting options: 0–15 characters (0–9, *, #)