2N 4G wireless router 2N SpeedRoute - User manual, 1898 v1.02 - Manual (Page 31)

Table of Programmable Parameters 3.2
31
Mobile technology select
Set the technology to be used by 2N ® SpeedRoute for connection to mobile
network.
Setting options: 2G (GSM) permitted/disabled
3G (UMTS, HSPA, HSPA+) permitted/disabled
4G (LTE) permitted/disabled (LTE versions only)
Default setting: All accessible technologies permitted
Caution
n By setting a technology you disable 2N ® SpeedRoute from using the
optimum technology, which may decelerate your data transmission or
make the connection impossible. Thus, we recommend you to keep the
factory settings.
Selection mode
Define how the provider should be selected. When Automatic is selected, the
provider is automatically. in case that Manually is selected, the following
Operator code must be filled. Selection Manual/Automatic gives the priority to
the operator according to Operator code, when this operator is not accessible, the
selection is done automatically. Deregister causes the disconnection from
currently used network.
Operator code (MCC+MNC)
The provider code is an identifier consisting of the Mobile Country Code (MCC) and
the Mobile Network Code (MNC). Use the parameter to select the provider to
which 2N ® SpeedRoute with a SIM should log for roaming purposes. Just select a
provider from the list of available networks and the provider code will be set
automatically.
Setting options: 5-6 characters [0-9], MCC – 3 digits, MNC – 2-3 digits
Available networks
List of available mobile networks to which your 2N ® SpeedRoute can log in. The
gateway only works if logged in to a network that enables roaming for the
gateway SIM card provider.
Tip
n Click on Scanner to display the up-to-date list of available networks.
Having searched the LTE/UMTS/GSM network according to the available
band, access technology and provider settings, 2N® SpeedRoute shall
provide a list of available networks.
Signal
Displays the current strength of the receiving signal in [dBm].
Operator
Displays the name of the provider to which the SIM is logged in. If the SIM card
cannot log in to a network (e.g. requires the PIN), the Limited service message
is displayed.