2N 4G wireless router 2N SpeedRoute - User manual, 1898 v1.02 - Manual (Page 69)

Table of Programmable Parameters 3.2
69
SSH - Forwarding
The SSH forwarding function allows for port forwarding using the SSH tunnel.
Location
Select the side to initiate the connection: Remote/Local.
Port
Set the port number to which requirements of the device connected to
2N ® SpeedRoute should be routed.
Target
Set the IP address and port to which the connection is routed.
Setting options: IP address:port number
PING
The PING function allows for checking the connection with the defined server.
Enable
Enable the function.
ICMP echo server
Define the server to be checked by the PING service.
Setting options: server name or IP address
Interval
Set the checking interval for the server connection check.
Timeout
Set the maximum server response time.
Max failures before re-connect
Set the maximum count of attempts before the Peer-to-Peer Protocol (PPP) is
restarted in 2N
® SpeedRoute.
Setting options: 0 to 1,000 (0 – no restart, 0 is not displayed)