Table of programmable parameters 3.2, Snmp – snmpv1, 2, Snmp – snmpv3 – 2N 4G wireless router 2N SpeedRoute - User manual, 1898 v1.02 User Manual
Page 65
Table of Programmable Parameters
3.2
65
Vendor OID
Vendor identification attribute to be used for all device with SNMP implemented.
These attributes are administered by IANA (Internet Assigned Numbers
Authority). Prefix for company 2N TELEKOMUNIKACE is:
1.3.6.1.4.1.6530 (iso.org.dod.internet.private.enterprises.tel2n)
SNMP – SNMPv1, 2
Permits using SNMP protocol version 1 and 2. These versions are not encrypted,
this is the reason why the permission of these versions is separated from version
3.
Enable
Enables using SNMP protocol version 1 and 2.
Tip
n
If not selected, no traps in version 1 or 2 are sent, all incoming requests in
these versions are ignored.
Community name
Specifies to which community will be the device assigned. On the monitoring
center are devices obviously joint into communities, to distinguish groups of
users. For common use is usually set the community ‘public’.
Access Rights
Specifies which rights have users accessing to the device using SNMP requests.
Setting options:
Read only
Read Write
Note
n
Setting Read only prevents change of setting, requests type SET REQUEST
are ignored.
SNMP – SNMPv3
SNMP v3 changes not only encrypted communication, but there are significant
changes in concept and terminology. This is the reason why the setting is
separated from older versions.