Application use – 2N M2M Solution 2N SmartCom - User Manual 1.9.0 User Manual

Page 70

2N TELEKOMUNIKACE a.s., www.2n.cz

Application Use

Tip

Not all tags are accessible to all device models.

General, RS-232, RS-485/M-Bus, Error buffer, Own AT

and

commands, FW upload, User defined functions

IP access

are accessible to all terminals.

and

are available to the

WM-Bus, RTC settings

Charger

SC PRO

and

terminals only.

SC PRO ETH

is accessible to the

terminals only.

Ethernet

SC PRO ETH

Having read configuration, go to the

tag of the

section.

General

Parameters

Figure: General Menu

Here you can set all parameters comfortably as you can with the AT commands
described in

, i.e. GSM commands plus automatic answer parameters. Push

S. 4

Save

o save the values. Push

to apply the changes immediately.

Save and restart

The Ethernet menu is only available to terminals equipped with an Ethernet port. Set
the primary data flow channel, LED signalling functions, obtaining IP address from the
DHCP server or static obtaining and DNS server use.