2N M2M Solution 2N SmartCom - User Manual 1.9.0 User Manual
Page 51
51
Tip
You can find different message formats is earlier FW versions:
^SCWMBUS:
There is a difference in data contents in this message: three
information bytes on the Radiocrafts module are added to the end.
at^scwmbus="get_oldest"<,n>
Enter the command to enable mass read-out of the messages. The optional n
parameter defines how many messages are to be read out.
at^scwmbus="del_oldest"
Enter the command to delete the oldest record from the Wireless M-Bus meter
data space. Delete the oldest record and enter the 'get_oldest' command to read
the oldest but one record.
at^scwmbus="del_oldest"<,n>
Enter the command to enable mass deletion of the messages. The optional n
parameter defines how many messages are to be deleted.
at^scwmbus="del_all"
Enter the command to delete all records from the Wireless M-Bus meter data
space.
at^scwmbus="mode",11
Enter the command to set the device operating mode.
1 - T1
3- S1
8- C1
11- T1+C
17 - N1
Note
The 17 - N1 mode is available only if the terminal is equipped with a
WMbus module, which supports the mode.
at^scwmbus="get_space"
Enter the command to display free memory space for WM-bus message storing.
at^scwmbus="mess_cnt"
Enter the command to display the count of WM-bus messages received.
at^scwmbus="RF_channel",1