2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 46)

46
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Enter the command to add an IP address to the list end. When the maximum
count of addresses in the list is reached, the command will be rejected.
at^scipauth="remove",1-5
Enter the command to remove an IP address from the list. Select the position
using parameters 1 to 5.
at^scipauth="clear"
Enter the command to delete all IP addresses from the list.
at^scipauth?
Enter the command to write out the list of set IP addresses.
SCIPAUTH: 1> "90.182.112.54"
SCIPAUTH: 2> "90.182.112.5"
at^scipauth=?
Enter the command to display the setting options for the interface.
SCIPAUTH: "ADD","15"
SCIPAUTH: "REMOVE",1-5
SCIPAUTH: "CLEAR"
Test Command
This command is used for terminal testing. Enter this command to monitor the terminal
state for provider's or Server connection troubleshooting purposes, 2N SmartCOM
®
for example.
at^sctest
Enter the command to test the basic functions of the terminal: GSM module login
to the provider's network, GPRS data connection operability and 2N SmartCOM
®
Server connection, for example. You will get the following reply, for example:
at^sctest
OK
Entering the test mode
GSM state: GPRS running
-testing GSM module: running
-testing MUX running: OK
-testing MUX command: OK
-testing SIM presence: OK
-checking SIM state: SIM ready
-checking GSM registration: local network
-testing signal strength: -65dBm (STRONG)
-reading operator name: "T-Mobile CZ"
-reading local address: "10.168.174.3"
SmartCOM mode: "TCPCLIENT"