2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 132)

132
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Enter this command to set the port for AT API.
–sLogLevel
Enter this command to set the level for logs. (1 – 5)
–sMaxUser
Enter this command to set the maximum number of users connected to the
server at the same time. The maximum value for the parameter is given by the
licence.
–sMaxTerm
Enter this command to set the maximum number of terminals connected to the
server at the same time. The maximum value for the parameter is given by the
licence.
–sKeepAliveTimeout
Enter this command to set the timeout for the client (user/terminal) to answer
the periodical KeepAlive packet in order not to be disconnected. Select a higher
value if a high number of terminals (100+) are used to avoid disconnection.
–sKeepAlivePeriod
Enter this command to set the interval between the KeepAlive packets. This
number should be higher than the KEEP_ALIVE_TIMEOUT.
–sResetAdmin
Enter this command to reset the Admin user password to '2n'.
-sTerminalPV1url
Sets URL for update of terminals with the SmartCOM protocol version 1 (the
oldest ones). Use parameter '-reset' to reset URL to the default value ('
'). http://star.2n.cz/~fejfar/SC_1-3-1-3-2.bin
-sEncryptionKey
Set packet encryption key. 32 hexa characters.
-sEncryptionMode
Set packet encryption mode (0: disabled, 1: optional, 2: forced).
Server commands
–cStartServer
Enter the command to start the Server service. 2N SmartCOM
®
–cStopServer