2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 112)

112
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Enter the command to know the terminal state. The reply is as follows:
Terminal state:
imei: 355915030753263
operator name: T–Mobile CZ (23001)
signal: 21
iccid: 8942001105088009270
imsi: 230015001013627
terminal serial number: 50–0369–0075
terminal firmware: 1.4.0.4.0
module firmware: L23_00gg.WISMO228 140711
module manufacturer: WAVECOM MODEM
module type: WISMO228
at^screl#?
Enter the command to know the state of the relay on the selected terminal.
at^screl#=
Enter the command to set the relay contact position.
at^screl#=,
Enter the command to set the relay contact position and define the contact
behaviour after the terminal restart.
at^scdin#="get_value"
Enter the command to read the value from the digital input.
at^scadc#="get_value"
Enter the command to read the value from the analogue input.
Port Settings
at^scport#?
Enter the command to know the current port configuration. The reply is as
follows:
^SCPORT1, "BAUDRATE",115200
^SCPORT1, "DATA BITS",8
^SCPORT1, "PARITY",0
^SCPORT1, "STOP BITS",1
^SCPORT1, "FLOWCONTROL",0
at^scport#[port]=,,
,,