JLG X23J Operator Manual - Manual (Page 56)

4.1.1 Display
The display is used to view the status of the machine and the operational information neces‑
sary or useful to the operator for use.
When the machine main control board is powered through the engine key, the information to
be seen on the display is sent to the remote control.
This operation has variable duration. Normally a few seconds are enough, but the following
screen may appear on the display:
In this case about 5‑10 minutes will be required to send all of the information from the main
board to the remote control. The machine does not function during this period.
Do not turn off the machine or operate on it during this period.
4.1.1.1 Display main screen
On switch on, the main screen will appear, which will give a general idea of the machine sta‑
tus. For simplicity and clarity a layout is created in which 8 icon display positions are identi‑
fied.
Example of main screen: Icon position layout:
BOOM LIFT MODELS X23J
JLG
52 X23JR0620113