JLG X23J Operator Manual - Manual (Page 27)

23
A LWAYS WEAR TYPE ‑ APPROVED AND CERTIFIED THE SLINGING . W HEN WORKING AT A HEIGHT MAKE
SURE YOU ARE WEARING THE SAFETY BELTS CORRECTLY AND THEY HAVE BEEN APPROPRIATELY ATTA
‑
CHED TO THE RELEVANT ANCHORAGE POINTS ON THE BASKET .
T
HE USE OF THE SLINGINGS IS COMPULSORY IN CONNECTION WITH THE LOCAL REGULATINS OF
EVERY SINGLE S TATE . I N THOSE S TATES WHERE THE LAW DOES NOT REQUIRE THE USE OF HOLDING
SYSTEMS
,
THE CHOICE IS OF THE EMPLOYER OR
/
AND USER
Safety valves and safety components of the electric system
It is prohibited to modify and/or tamper with the safety and control valves of the main
hydraulic system and the adjustments of the electric plant. The Constructor is not liable
for injury to persons and damage to objects or to the machine if the standard calibration
of any hydraulic and electric/electronic component is tampered with.
Fire prevention
Keep the area around the engine clean, removing fragments of
wood, paper and other inflammable products; clean any fuel
leaks as they can be a potential cause of fire.
Petrol is extremely inflammable and explosive in particular
conditions. Re‑fuel in a well‑aired place with the engine at a
standstill.
Do not smoke or make sparks in the re‑fuel area or fuel stora‑
ge area.
After having re‑fuelled, make sure the cap is closed securely.
Do not touch the exhaust when hot during machine functioning or immediately after the
engine is switched off.
Prevention of damage caused by washing the machine
Do not aim high pressure jets onto electric components when
washing the machine. Do not use chemical detergents or
petrol that could cause serious damage to plastic components
and the paintwork.
A
LWAYS REMEMBER TO REMOVE THE REMOTE CONTROL AND COR ‑
RECTLY CLOSE THE REMOTE CONTROL CONNECTION SOCKETS AND
EQUIPMENT POSITIONED ON THE MACHINE , BEFORE WASHING .
BOOM LIFT MODELS X23J
JLG
X23JR0620113
IMPORTANTE
IMPORTANT