JLG X23J Operator Manual - Manual (Page 176)

BOOM LIFT MODELS X23J
JLG
172 X23JR0620113
PROBLEMS CAUSES SOLUTIONS
At the end of the job it is not
possible to de‑stabilise the
equipment • The aerial part has not been
put perfectly into the rest
position
• The photocells are
faulty/incorrect
• Repeat the procedure for
putting the aerial part of the
machine to rest and check
the correct signal from the
photocells
During use of the aerial part
vibrations and unsteadiness
in the extension manoeuvre
and work arm retraction
speed are detected • Telescopic arm and slide
blocks are sparsely lubricated
• Slide blocks worn
• Lubricate arm and slide
blocks
• Adjust slide blocks
The work platform does not
remain level during move‑
ment of the arm • Air in the levelling system
• The balancing valve on the
levelling plant is faulty
or is not calibrated
• Bleed the air from the
work platform levelling
system (consult our technical
after‑sales service)
•Replace the work platform
levelling plant balancing
valve.
The movement of the first
and second arm is not regu‑
lar • Accumulator discharged • Replace the accumulator
(consult our technical after‑
sales service).