Eppendorf Galaxy Gas Analyzer - Manual (Page 33)

33
Galaxy® CO2 Sensor Setup — Instructions
Galaxy 14 with O
2
option
NOTE: O
2
inlet connector assembly is adjacent to sensor bracket, but does not cause an
obstruction.
6. Connect the existing wiring harness to the CO
2
Sensor connecting block (as shown on top left
and right-hand image, page 34). Ensure you have stripped 7 mm of insulation from the
existing harness wires and twisted the strands before connecting them.
NOTE: Green on the existing harness connects to Brown on the new CO
2
Sensor assembly
harness.
A Illustrates O
2
inlet connector assembly
3
Galax
y 48 S
/ 14
S 120 V & 230 V CO
2
Incubators