Eppendorf FemtoJet - Manual (Page 37)

35
5 Troubleshooting
Error 13
Supply pressure does not rise
Possible cause: Technical defect
Solution: Service
Error 14
Massive leak in pressure accumulator
Possible cause: Technical defect
Solution: Service
Error 15
Leak in pressure accumulator
Possible cause: Technical defect
Solution: Service
Error 16
Leak through Valve V1 is too large
Possible cause: Technical defect
Solution: Service
Error 20
Working pressure has not been reached
Compressor runs without supply
pressure being reached within a specific
time.
Possible cause:
Capillary holder not attached or poorly
attached. (Broken) capillary with large
opening.
Technical defect.
Solution:
Check the capillary. Check the capillary
holder and tube for leaks or tighten up the
tube connections.
Service.
ERROR 013
Supply pressure is
does not raise
INJECT = Continue
ERROR 014
Supply pressure
leak is too high
INJECT = Continue
ERROR 015
Supply pressure
leak is too high
INJECT = Continue
ERROR 016
Valve 1 pressure
leak is too high
INJECT = Continue
ERROR 020
Working pressure
cannot be reached
INJECT = Continue
05_Fehler_en.fm Seite 35 Mittwoch, 27. September 2006 5:14 17