Eppendorf FemtoJet - Manual (Page 18)

16
3 Mode of operation
Standby
in the case of a brief interruption
When key is pressed briefly:
The device switches to the Standby
mode
without deairing. The illumination
of the display switches off. "STANDBY"
appears in the display with the suffix
"Supply pressure = rxyz" as a code for
system pressure p
s
being maintained.
Application:
For temporary interruptions or use of
as a Reset function.
When key is pressed again:
The device is reactivated and runs
through a short warm-up routine.
This lasts approximately one minute.
Standby
with deairing of pressure accumulator
Hold down the key (approx. 2 seconds;
the display moves to "STANDBY"):
The device switches to the Standby
mode. The pressure accumulator is
completely deaired, the illumination of
the display switches off. "STANDBY"
appears in the display with the note
"Supply pressure = x" (x ~ 0).
A noise can be heard at this stage.
Application:
For correct shutdown, with deairing of the
entire pressure system in the event of
longer periods of non-use or standstill
(weekend or storage) with subsequent
switch-off using the mains switch.
Press the key again:
The device is reactivated and runs
through the warm-up routine.
This takes approximately three minutes.
STANDBY
Supply pressure 6789
Hold standby
to exhaust
STANDBY
Supply pressure 0
03_Bedien_en.fm Seite 16 Mittwoch, 27. September 2006 5:12 17