Eppendorf FemtoJet - Manual (Page 29)

27
3 Mode of operation
3.7.1 Changing the capillaries
3.7.2 Setting the pressure unit
3.7.3 Switching on/off the loudspeaker
3.7.4 Switching on/off the background illumination of the display
FUNC 0
When this function is called up, the
injection tube is deaired and any
pressure present in the system is let out.
Once the capillary has been changed,
exit the function using the key or
variable regulator p
i
; pressure control will
restart.
FUNC 1
The other pressure unit is selected using
the key and all pressure values
are converted. The pressure unit
currently selected (in this case: hPa)
is underlined.
FUNC 2
Use the
key to switch the
loudspeaker on or off. The currently
selected setting (in this case: ON) is
underlined. Acoustic error messages are
not emitted if the setting
is OFF.
FUNC 3
Use the
key to switch the
illumination on or off. The currently
selected setting (in this case: ON) is
underlined.
In the normal operating mode,
illumination switches off after three
minutes if no operating control has been
actuated. When an operating control is
actuated, the illumination lights up again.
FUNC 0
Change capillary
Capillary may be
changed now
Turn pi to
select function
FUNC 1
Push Inject to select
Pressure Unit
hPa PSI
Turn pi to
select function
FUNC 2
Push Inject to select
Beeper ON OFF
Turn pi to
select function
FUNC 3
Push Inject to select
Illumination
ON OFF
Turn pi to
select function
03_Bedien_en.fm Seite 27 Mittwoch, 27. September 2006 5:12 17