SkyTrak 6036 Operation Manual - Manual (Page 74)

Page 68
6036/6036T
ACCESS
HOLE IN TRANSMISSON COVER
COVER MOUNTING NUTS
Figure 45
OA0392
MIL-L-2104C
10W Motor Oil *
Castrol Deusol CRD
Esso Essolube D-3HP
Esso Essolube XD-3
Castrol Agricastrol HDD
Shell Rimula CT
Shell Rimula X
Shell Rimula TX
* 5W20 Motor Oil may be
substituted for -30° F to
70° F (-34 to 21° C) only.
4. Add MIL-L-2104C Oil
(See table on this
page) to transmis-
sion as required to
bring up to full mark.
Transmission capac-
ity is 4.3 gallons
(16,3 liters).
16. Start the engine and operate the pump at least
two minutes at no load and at a speed of over
400 rpm but below 1500 rpm. During this break-
in period, the unit should run free and not develop
an excessive amount of heat. If the unit operates
properly, speed and pressure can be increased to
normal operating settings.
17. Run vehicle and operate all hydraulic functions.
Then, check for leaks.
18. Re-install hydraulic tank access cover.
8. Transmission Oil and Filter
A. Level Check (50 Hour Intervals)
1. Level the vehicle, ground the carriage, and place
travel select lever in (N) Neutral, and engage the
emergency brake switch.
2. Check oil level with engine running at idle, and oil
at normal operating temperature.
3. Remove transmission dipstick through access
hole in cover (Figure 45). Check reading.