SkyTrak 6036 Operation Manual - Manual (Page 54)

Page 48
6036/6036T
1. Lubrication Points
Lubricate the following grease fittings using Multi-Purpose
Grease (MPG) every 50 hour interval (Fig. 21 and 22):
A. Hydraulic cylinder pins .............. (10 points)
B. Drive shaft slip joints ................. (3 points)
C. Boom chain sheaves ................ (2 or 1 points)
D. Boom pivot pins ........................ (2 points)
E. Carriage pivot pin ..................... (2 points)
F. Axle pivot pins .......................... (4 points)
G. Boom Attachments ................... (All points)
Figure 21
OA0182
Lubricate the following grease fittings using Multi-Purpose
Grease (MPG) every 250 hour interval (Figure 22):
H. Axle steer knuckles ................... (8 points)
J.
Axle tie rod ball joints ................ (4 points)
K. Axle steer cylinder ball joints .... (8 points)
NOTE: Shorten the lubrication interval on all axle and
drive shaft lube points, and lower frame tilt and hoist
cylinder pins when operating in wet or muddy conditions.
OA0192
Figure 22
H
K
F
J
H
A
A
D A A
A
E
B
C (FIG. 57)
A
G
C (FIG. 56)
THIS GREASE FITTING IS ON
EARLY PRODUCTION ONLY.