beautypg.com

SkyTrak 6036 Operation Manual User Manual

Page 61

background image

Page 55

6036/6036T

5.

Allow oil to drain completely into receptacle.
Transfer the oil to a container with a cover and
label the container as used oil. Dispose of the
used oil at an approved recycling facility.

6.

For Perkins Engines: Unlock and open the
right rear engine access door. Remove oil filter
(Figure 27). A strap or chain filter wrench may
be required.
For Cummins Engines: Unlock and open the
left rear engine access door. Remove oil filter
(Figure 29A). A strap or chain filter wrench
may be required.

7.

Clean filter sealing surface.

NOTE: The filter o-ring may stick to the filter head. Make
sure the old o-ring is removed before installing new filter.

8.

Apply a thin coat of clean engine oil to seal on
new filter.

9.

Install the new oil filter and hand tighten 1/2
turn after initial contact.

10.

Clean and re-install oil pan drain plug.

4.

If oil is below the add mark, add 15W40 or 10W30
motor oil that is equal to API, CD or CE (severe
duty diesel engine) specifications. Replace dip-
stick. Close and lock access door.

Engine Oil Type

Ambient Temperature

10W30

Below 23° F (-5° C)

15W40

Above 23° F (-5° C)

IMPORTANT: The use of quality engine oil combined with
appropriate oil and filter change intervals are critical factors
in maintaining engine performance and durability. The use
of multi-viscosity, 15W40, oil is recommended for most
climates. Low viscosity, 10W30, oil may be used at colder
temperatures. However, continuous use of low viscosity oil
may decrease engine life due to wear.

B.

Oil and Filter Change (250 Hour Intervals)

1.

Operate engine until warm (approx. 5 minutes).

2.

Level the vehicle, ground the carriage, place the
travel select lever in (N) Neutral, engage the
emergency brake switch and shut off the engine.

3.

Place receptacle under engine oil pan drain.

4.

Remove drain plug from engine oil pan.