SkyTrak 6036 Operation Manual - Manual (Page 37)

Page 31
6036/6036T
4. Raise the boom until the boom hook pins have
seated fully in the hooks on the attachment.
5. Pull the attachment tilt control lever backward until
the front of the attachment starts to raise. The
quick attach link should be tight up against the
rear of the attachment and the holes in the link
and the attachment should be aligned.
PIN LOCK LEVER
QUICK ATTACH PIN
OA0152 Figure 16
6. Place travel select lever in (N) Neutral, engage
emergency brake switch and exit the vehicle
using the hand holds.
Warning
DO NOT operate this vehicle unless you are in the
seat with the seat belt fastened around you. Serious
injury or death could result if the belt is not securely
fastened.
8. Return to the operator’s compartment, fasten seat
belt and resume operation.
7. Lift lever. Insert the quick attach pin completely
through the attachment and quick attach link. Be
sure that the quick attach lock lever has lowered
and seated itself into the groove in the quick
attach pin.