SkyTrak 6036 Operation Manual - Manual (Page 30)

Page 24
6036/6036T
If using starting fluid without metering equipment:
Warning
NEVER use starting fluid near an open flame, or with
electric preheater or flame air heater equipment.
Serious injury or death could result from explosion.
DO NOT breathe starting fluid fumes. Serious injury
or death could result from toxic fumes.
DO NOT use excessive amounts of starting fluid
when starting an engine. Serious injury or death
could result from a backfire of flame which could
ignite the starting fluid canister and cause an
explosion.
5. Depress the accelerator pedal to half speed.
6. If using starting fluid with mechanical or electrical
metering equipment:
Turn the ignition switch to the START position to
engage the starter motor and inject metered
amounts of starting fluid.
As the engine starts, stop injection of starting fluid
and release the ignition key to the RUN position.
Release the accelerator pedal to give a smooth idle
speed.
2. Fasten seat belt.
3. Check that the emergency brake switch is engaged.
4. Place the travel select lever in (N) Neutral.
Warning
DO NOT start the engine unless you are in the seat
with the seat belt fastened around you. Serious
injury or death could result if the belt is not securely
fastened.
Cold Starting
(Cummins Engines Only)
The cummins engine on this vehicle is not normally
equipped with a cold starting aid. Cold starting aids such
as mechanical or electrical ether metering equipment or
block heaters are recommended when temperatures are
below 10° F (-12° C).
(Temperature ranges will vary when
using different oil weights. Consult the engine
manufacturer's manual for other variables).
At temperatures below 10° F (-12° C), operate the engine
at moderate speeds for 5 minutes before full loads are
applied.
1.
using hand holds, enter the cab and adjust the
operator's seat for comfortable operation.