Installation instruc tio ns – Poison Spyder JK LED LICENSE PLATE & 3RD BRAKE LIGHT User Manual

Page 5

INSTALLATION INSTRUC

TIO

Poison Spyder Customs • JK LED License Plate & 3rd Brake Light Install

Page 5

FIGURE 17

18. Reinstall the white plastic pin lock into the

open end of the taillight connector. Use a

pick or screwdriver to push it in until it locks

into place.

FIGURE 18

19. Plug the Poison Spyder LED Taillight

Harness into the OE taillight connector.

FIGURE 19

20. Route the long gray license plate light

lead to wherever you are going to mount the

license plate light, typically at the center of

the spare tire on the spare tire carrier. To

route the wire to the exterior of the Jeep,

reach inside the Jeep’s corner cavity, down

to the “floor” inside. There is a hole in this

floor under a thick piece of foam insulation.

This hole can be used to route the wiring to

the exterior of the Jeep.

21. Use hardware of your own choosing to

mount the License Plate & 3rd Brake Light

along with the license plate in the location

you have chosen. Use zip-ties to secure

the wiring lead along its path. Make sure it

has enough slack at the tire carrier hinge to

provide for full movement of the tire carrier.

22. Continue with the remaining steps of the

JK LED Taillight Harness installation from the

instructions included with that product.

Congratulations, you have completed the

installation of your Poison Spyder JK LED

Taillight Harness!