Poison Spyder JK LED LICENSE PLATE & 3RD BRAKE LIGHT - Manual (Page 3)

INSTALLATION INSTRUC
TIO
NS
Poison Spyder Customs • JK LED License Plate & 3rd Brake Light Install Page 3
©2014 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
FIGURE 8
8. Insert the other end of the air hose into the
open end of the nylon wire sheath, from the
tailgate end. Push it through the sheath until
it comes out the other end, then grip the hose
and pull it, along with the brake light jumper
wire, through the sheath. After a few inches
of the jumper wire are through the sheath,
gently remove the air hose from the end of
the wire.
FIGURE 9
9. The pin end of the brake light jumper wire
must now be passed through the rubber
grommet alongside the OE taillight wiring.
Be sure you are passing the wire through in
the correct direction. A squirt of WD-40 into
the narrow neck of the grommet will help it
pass through easily.
FIGURE 10
10. Pull enough of the jumper wire through the
grommet that it can reach the OE taillight
plug. Then push the taillight plug and the
end of the jumper wire back through the hole
in the body tub, into the cavity behind the
taillight, and press the grommet back into
place.
FIGURE 11
11. Route the other end of the brake light
jumper wire alongside the existing wiring
harness across the tailgate. Either coil it
around the existing wiring or use zip-ties to
hold it in place.
FIGURE 12
12. The square plug on the end of the jumper
wire is passed through the hole in the