Poison Spyder JK LED LICENSE PLATE & 3RD BRAKE LIGHT - Manual (Page 2)

INSTALLATION INSTRUC
TIO
NS
Poison Spyder Customs • JK LED License Plate & 3rd Brake Light Install Page 2
©2014 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
FIGURE 4
3. Just inside the small vertical cover, find
the small rectangular plug where the Jeep’s
OE third brake light wiring connects to the
chassis harness. Unplug the OE third brake
light wiring if it is present. The OE third brake
light should also be removed, if still present
(instructions for doing so are not included
here).
4. Inside the Jeep, peel back the carpet at
the rear passenger side corner of the Jeep’s
interior, to expose the areas where the wiring
from the tailgate runs. On some Jeeps there
may be a speaker enclosure which will have
to be removed to gain access.
FIGURE 5
5. Follow the wiring from the tailgate up into
the corner of the Jeep’s interior, to where it
passes through the body tub with a rubber
grommet. Grip the grommet along the edges
to dislodge it, then pull it and the taillight
connector plug through the hole into the
Jeep’s interior.
FIGURE 6
6. Where the tailgate wiring transitions from
the tailgate to the Jeep’s body, it passes
through a flexible sheath of nylon webbing.
Both ends of the sheath are secured by plastic
zip style wire loom holders. These may be
released by using a pick to carefully depress
the small tang inside the zip housing, and
pulling on the strap. Each end of the sheath
is also secured to the wires with electrical
tape, which will also need to be removed so
that both ends of the sheath are open.
FIGURE 7
7. Find and uncoil the white brake light
jumper wire that was included in the kit with
the passenger side harness. Also find the
18” length of 1/4” air brake hose that was
included. At one end of the jumper wire, a
metal pin and rubber seal have already been
installed. Push this metal pin into one end
of the hose until the rubber seal is just inside
the end of the hose, so that it is firmly gripped
by the hose.