Installation instruc tio ns – Poison Spyder JK LED TAILLIGHT HARNESS User Manual

Page 2

INSTALLATION INSTRUC

TIO

Poison Spyder Customs • JK LED Taillight Harness Installation

Page 2

FIGURE 1

3. With your thumb, press on the release tab

of the taillight harness plug, and separate it

from the vehicle harness. Set the OE taillight

assembly aside.

FIGURE 2

NOTE: At this point, provisions will have to be

made for physically mounting the 4” round LED

taillight. In most cases, this means installing

Poison Spyder Crusher Corners. Instructions

for doing that are not included here. These

instructions continue with the assumption that

the Jeep is now ready to mount the 4” round

LED taillights (and 2-1/2” round reverse lights,

if applicable)
NOTE: If installing Poison Spyder’s LED License

Plate & 3rd Brake Light in conjunction with this

installation, insert the procedures included with

that product into the installation process here.
4. Plug the Poison Spyder LED Taillight

Harness into the OE taillight connector.

FIGURE 19

5. Secure the gold anodized resistor heat

sink into place inside the Jeep’s corner cavity.

This may be done by using a couple of small

self-tapping sheet metal screws and a long

driver extension for your drill, to secure it to

the flat surface inside the cavity. Be sure

not to chose a surface where the ends of

the sheet metal screws will protrude into the

Jeep’s interior.

FIGURE 20

6. If installing the LED License Plate & 3rd

Brake Light, route the long gray license plate

light lead to wherever you are going to mount

the license plate light, typically at the center

of the spare tire on the spare tire carrier. To

route the wire to the exterior of the Jeep,

reach inside the Jeep’s corner cavity, down

to the “floor” inside. There is a hole in this

floor under a thick piece of foam insulation.

This hole can be used to route the wiring to

the exterior of the Jeep.

7. Route the back-up light extension

harness(es), if needed. There are two plugs

provided on the harness for these. For backup

lights mounted down in the bumper, use the

24” extension harnesses and route through

the hole in the floor of the corner cavity as