beautypg.com

Poison Spyder JK LED TAILLIGHT HARNESS User Manual

Installation instruc tio ns, Jk led taillight harness installation

background image

©2014 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM

INSTALLATION INSTRUC

TIO

NS

41-06-010-P • JK LED Taillight Harness - Passenger Side

41-06-010-D • JK LED Taillight Harness - Driver Side

41-06-020 • 24in LED Back-Up Light Extension Harness (Pair)

41-06-030 • 4in LED Back-Up Light Extension Harness (Pair)

Thank you for purchasing Poison Spyder’s JK

LED Taillight Harness system. Depending on

the components you chose, you may not have all

of the items shown in the photos above. Simply

disregard the instructions for any components

you are not using in your own installation.
Installation is fairly simple with the right tools

and good mechanical abilities. If you are not

confident in your mechanical skills, please

seek the help of a professional to perform the

installation. Please read through these entire

instructions before proceeding with installation.
Please check your packages immediately upon

arrival to ensure that everything you ordered

is included, and to check for damage during

shipping. If anything is missing or damaged,

call Poison Spyder at (951) 849-5911 as soon

as possible.

TOOLS NEEDED

• Phillips screwdriver
• Zip-ties
• Sheet metal screws & drill with driver bit

NOTE: Installation assumes the use of 4” round

LED taillights and 2-1/2” round LED back-up

lights sold by Poison Spyder Customs. Other

manufacturers’ lighting products may also be

compatible, however they are not guaranteed to

work with this harness.

INSTALLATION PROCEDURE
1. Park vehicle on a level
surface, place the

transmission in gear or park, and set the

emergency brake. Wear safety glasses from

this point on.

2. Beginning on the passenger side, use

a Phillips screwdriver to remove the stock

taillight assembly from the Jeep. Note that

there are four screws, one in each corner

of the taillight housing. You only need to

remove the two inboard screws. Once these

two screws are removed, grip the taillight

assembly, slide it slightly toward the center

of the Jeep and pop it out.

JK LED TAILLIGHT HARNESS INSTALLATION