Installation instruc tio ns – Poison Spyder CJ ROCKBRAWLER REAR BUMPER WITH TIRE CARRIER User Manual

Page 6

INSTALLATION INSTRUC

TIO

Poison Spyder Customs • TJ-YJ-CJ ROCKBRAWLER REAR BUMPER

Page 6

37. Once the entire bumper is mounted

and tested for proper operation, remove

and disassemble the bumper for paint or

powder coat. If painting yourself, careful

preparation will make a big difference in the

quality and longevity of your paint job, even

using “rattle can” aerosol paints. Begin by

thoroughly cleaning the bumper with solvent

or de-greaser, then make sure all residue is

removed. Even if you use cheap paint, try to

use a good quality primer. “Etching” primers

are best to use on bare, unpainted metal.

Allow it to properly dry before painting, and

between paint coats. Note that the Spyder

Web Gusset Detail is detachable so that it may

be painted or powder coated a contrasting

color from the rest of the bumper.

If powder coating, make sure the entire bumper

and tire carrier are completely disassembled first.

Make sure the latch mechanism, bearings and

races or grease seal are not yet installed. Make

sure your powder-coater understands that the

hinge spindle must be masked off (not coated).
Do not paint or powder coat the crescent-shaped

stainless steel Lock Pin Slider Plate.
38. Once the bumper has been painted or

powder coated, re-install by repeating the

above steps.

Congratulations, you have completed installation

of your RockBrawler Rear Bumper and Tire

Carrier!

This manual is related to the following products: