Hale 80FC - Manual (Page 100)

❑ Corrective Maintenance
100 Pump Ends
p/n: 029-0020-61-0
Figure 6a-8: Replacing 40FB - 100FB Series Pump Shaft Oil Seal
2. Pull the pump head assembly, including the pump shaft from the bell hous-
ing, using appropriate hoist, and move the assembly to a suitable work
area. Safely support the assembly.
WARNING !
SECURE THE PUMP HEAD ASSEMBLY TO AN APPROPRIATE HOIST TO PRE-
VENT POSSIBLE INJURY OR DAMAGE.
3. Remove the four (4) 3/8”-16 screws and sealing washers to remove the
bearing extension cover and expose the pump shaft bearings (2). (See Fig-
ure 6a-8: “Replacing 40FB - 100FB Series Pump Shaft Oil Seal” on page
100.)