Konica Minolta bizhub C35 - Manual (Page 36)

[Fax Settings] (Admin Settings) 2-11
[Redial] Settings [0] - [10] ([1])
Specify the number of times this machine automati-
cally redials when a fax could not be sent correctly,
for example, if the line is busy or a communication
error occurred.
"
The available settings and the default setting
differ depending on the setting selected for
[Admin Settings] - [Fax Settings] - [Fax Target].
[Redial Interval] Settings [2] - [15] ([2])
Select the length of the interval (in minutes) between
redial attempts when the machine automatically redi-
als.
"
The available settings and the default setting
differ depending on the setting selected for
[Admin Settings] - [Fax Settings] - [Fax Target].
[Line Monitor] Settings [OFF] / [Until Connection Complete] /
[Until Transmission Complete]
Select whether the line monitoring tone is produced
during communication.
[OFF]: No line monitoring tone is produced.
[Until Connection Complete]: The line monitoring
tone is produced until the connection with the desti-
nation has been completed after dialing.
[Until Transmission Complete]: The line monitoring
tone is produced until the fax transmission has been
completed after dialing.
[Line Monitor Volume] Settings [Low] / [Medium] / [High]
Select the volume of the line monitoring tone.
[Ring Pattern] Settings [Normal Ring] / [Double] / [Triple 1] /
[Triple 2]
Select the ring pattern for faxing when [RX Mode] is
set to [DRPD].
"
For details on the settings, refer to “[Ring
Pattern]” on page 4-4.
Item Description