Konica Minolta IF-118 - Manual (Page 53)

3 Getting Ready
3-26 IF-118
Internet Fax Settings
POP3 Configuration
Port Number This function is used to specify the port number for the SMTP
server. Normally, port number 25 is used. (1 to 65535)
SMTP Server Timeout This function is used to specify the length of time (30 to 300
seconds) until the connection to the SMTP server times out.
Function Description
Function Description
Basic Mode/Advanced
Mode This function is used to specify the default settings for the Basic
and Advanced transmission modes when sending a document
by Internet fax (using the 10-key pad to enter the destination).
(“Basic Mode” or “Advanced Mode”)
Max TX Size This function is used to specify the maximum document size for
transmission when using the Advanced mode. (Metric models:
“A4”, “B4”, or “A3”; Inch models: “LT” or “11
×
17”)
Max Resolution This function is used to specify the maximum transmission
resolution when using the Advanced mode. (“Fine” or “Super
Fine”)
Coding Mode This function is used to specify the coding method for scan data
that is to be transmitted when using the Advanced mode.
(“MH”, “MR”, or “MMR”)
Function Description
POP3 Server Address This function is used to specify the IP address or host name of
the POP3 server. (Up to 64 characters)
Account Name This function is used to specify the account name used to log
in to the POP3 server. (Up to 64 characters)
Password This function is used to specify the password associated with
the account name used to log in to the POP3 server. (Up to 32
characters)
Auto Reception This function is used to specify the time interval (between 1 and
60 minutes) for checking e-mail when the Auto Reception
function is enabled.
Reply Address This function is used to specify the return e-mail address for
error messages. If an error occurs, an error message will be
sent to the e-mail address specified here. Normally, the reply
address is set to the e-mail address of the administrator. (Up to
64 characters)
Port Number This function is used to specify the port number for the POP3
server. Normally, port number 110 is used. (1 to 65535)
POP3 Server Timeout This function is used to specify the length of time (30 to 300
seconds) until the connection to the POP3 server times out.