Konica Minolta IF-118 - Manual (Page 37)

3 Getting Ready
3-10 IF-118
Specifying the Subnet Mask
1 From the “NETWORK SETTING”
menu in the Utility mode, press the
[2] key on the 10-key pad to select
“SUBNET MASK”.
2 Using the 10-key pad, enter the
subnet mask value.
❍ The illustration at the right is an
example of a subnet mask address. Consult your network
administrator for details about these settings.
3 Press the [YES] key.
The NETWORK SETTING screen appears. To register settings in the
copier, the copier must be turned off, then on again.
4 While the NETWORK SETTING screen is displayed, press the [NO]
key or [AUTO RESET] key so that the message “PLEASE RE-START
POWER SUPPLY OFF/ON” appears.
5 Set the power switch of the copier to “O”, then “I” to restart the copier.
Specifying the (Default) Gateway
1 From the “NETWORK SETTING”
menu in the Utility mode, press the
[3] key on the 10-key pad to select
“GATEWAY”.
2 Using the 10-key pad, enter the IP
address for the gateway.
❍ The illustration at the right is an
example of a gateway address.
Consult your network administrator for details about these settings.
3 Press the [YES] key.
The NETWORK SETTING screen appears. To register settings in the
copier, the copier must be turned off, then on again.
4 While the NETWORK SETTING screen is displayed, press the [NO]
key or [AUTO RESET] key so that the message “PLEASE RE-START
POWER SUPPLY OFF/ON” appears.