Konica Minolta IF-118 - Manual (Page 43)

3 Getting Ready
3-16 IF-118
Specifying the E-mail Mode Settings
This function specifies the default settings for the Basic and Advanced
transmission modes when sending a document by Internet fax (using the
10-key pad to enter the destination).
There are two transmission modes: Basic and Advanced. These can be
used to specify the maximum size, the maximum resolution, and the
encoding method to be used when sending a document.
If an Internet fax is sent using a size, resolution, or coding method that is
not supported by the device receiving the document, the recipient may not
be able to read the document. When sending a document by Internet fax,
the settings should be specified according to the receiving device. If these
settings are specified correctly, the document will be sent with the settings
appropriate for the recipient even if the settings are set when the job is
sent.
1 From the “E-MAIL SETTING 1 ”
menu in the Utility mode, press the
[8] key on the 10-key pad to select
“E-MAIL MODE”.
2 Press the and keys to
select the scan mode (“BASIC” or
“ADVANCED”), and then press the
[YES] key.
❍ If “ADVANCED” is selected, the screen for specifying the
maximum size of document that can be sent appears. (Go to step
3.)
❍ If “BASIC” is selected, the E-MAIL SETTING 1 screen appears
again.
Function Description
Basic Mode Advanced Mode
Maximum TX Size Inch models: LT
Metric models: A4 Inch models: LT, 11
×
17
Metric models:A4, B4, A3
Maximum Resolution Fine Fine, S/F (Superfine)
Coding Method MH MH, MR, MMR