Konica Minolta bizhub C350 - Manual (Page 34)

2 2.6 Administrator Code Change function
2-24 bizhub C350
A
d
mi
ni
st
ra
to
r O
p
er
at
io
n
s
Ch
apte
r 2
3 Touch [3/4], and then touch
[Administrator Code
Change].
4 Using the 10-Key Pad, type
in the currently specified 8-
digit Administrator Code.
❍ Press the [C] key to clear
all characters.
❍ Touch [Cancel] to go
back to the “Admin. Set.”
screen.
5 Touch [Enter].
✎
Note
If the entered Administrator Code is incorrect, the message “The entered
Administrator Code is incorrect. Please try again.” appears. Be sure to type
in the correct Administrator Code.
If the Unauthorized Access Lock function is set to “Enable”, incorrectly
entering the Administrator Code is counted as a failed authentication
attempt. If the Administrator Code is incorrectly entered three times, the
screen for entering the Administrator Code appears after the fourth failed
authentication attempt, the message “Access denied due to unauthorized
access. Cannot enter Administrator Mode.” appears when the Administrator
Code is entered, and the Administrator Code can no longer be entered. To
again allow access, turn the machine off, then on again.