Konica Minolta bizhub C350 - Manual (Page 33)

2.6 Administrator Code Change function 2
bizhub C350 2-23
A
d
mi
ni
st
ra
to
r O
p
er
at
io
n
s
Ch
apte
r 2
2.6 Administrator Code Change function
When access to Admin. Mode is authenticated, the Administrator Code can be
changed. In order to change the Administrator Code, the Administrator will be
authenticated again using the 8-digit Administrator Code. Next, type in the new 8-
digit Administrator Code (no more than eight digits can be entered), and then type
in the Administrator Code again for confirmation. The entered Administrator Code
appears as “*”. However, if the Unauthorized Access Lock function is set to
“Enable”, incorrectly entering the Administrator Code during confirmation is
counted as a failed authentication attempt. If the Administrator Code is incorrectly
entered three times after the appropriate operation is performed to clear the count,
access is denied after the fourth failed access authentication, access to Admin.
Mode is cancelled, and the Administrator Code can no longer be entered. To again
allow access, turn the machine off, then on again.
✎
Hint
For details on the operations for clearing failed access counts, refer to
“Conditions for Clearing the Access Failure Count” on page 1-3.
Changing the Administrator Code
1 Call the Admin. Mode to the screen from the control panel.
❍ For the procedure to be followed when calling the Admin. Mode to the
screen, see “Accessing the Admin. Mode” on page 2-2.
2 Touch [Admin. Set].