Avaya 555-233-116 User Manual
Page 72
Data modules and asynchronous data units
555-233-116
72
Issue 4 October 2002
10. If you enabled AT commands, the AT —> ON? prompt appears. Press the
ENTER/YES button.
11. If you enabled AT commands, the CONTINUE? prompt appears. Press the
ENTER/YES button.
Configuring the RS-232 interface on 7400A DTE
You can set each pin of the RS-232 cable to meet the needs of specific
applications, though in most cases, the defaults should work. For a list of pins and
leads, see
.
The Data Signal-Rate Select EIA leads—CI, CI2, CH, and CH2—of the RS-232
cable indicate the receive/transmit speeds that the data module can use. To set
the EIA signal-rate leads, proceed as follows:
1. From the HOME display, press NEXT/NO until SET OPTIONS? appears.
Then press the ENTER/YES button.
2. When the SET 300 SPEED? prompt appears, press NEXT/NO until SET
CI LEAD? appears. Then, using the table and instructions below as a
guide, start setting the leads.
AT —> ON?
DATA
NEXT/NO
BACK
ENTER/YES
●
❍
❍
➜ ●
Push the button indicated by the arrow (
➜
)
CONTINUE?
DATA
NEXT/NO
BACK
ENTER/YES
●
❍
❍
➜ ●
Push the button indicated by the arrow (
➜
)
SET OPTIONS?
DATA
NEXT/NO
BACK
ENTER/YES
●
❍
❍
➜ ●
Push the button indicated by the arrow (
➜
)
SET CI LEAD?
DATA
NEXT/NO
BACK
ENTER/YES
●
❍
❍
➜ ●
Push the button indicated by the arrow (
➜
)