Avaya 555-233-116 - Manual (Page 53)

Set hardware options
Issue 4 October 2002 53 555-233-116
2. Otherwise, remove the access panel on the top of the case by grasping the
rear lip of the panel and pulling sharply upward.
3. Locate the DIP switch block, a bank of tiny switches on the circuit board, in
the center of the opening.
DIP switches 1, 5, and 8 control the attached telephone (if any), data
metering, and loopback on local loop.
4. Set the switches for the combination of options that you need to enable,
using the chart below as a guide.
No telephone attached, data metering OFF, busyout on local loop OFF
(factory default settings)
O
N
1 2 3 4 5 6 7 8 9
DOWN DOWN DOWN DOWN DOWN DOWN DOWN DOWN DOWN
Telephone attached, data metering OFF, busyout on local loop OFF
O
N
1 2 3 4 5 6 7 8 9
UP
DOWN DOWN DOWN DOWN DOWN DOWN DOWN DOWN
No telephone attached, data metering ON, busyout on local loop OFF
O
N
1 2 3 4 5 6 7 8 9
UP
DOWN DOWN DOWN DOWN DOWN DOWN DOWN DOWN
No telephone attached, data metering OFF, busyout on local loop ON
O
N
1 2 3 4 5 6 7 8 9
UP
DOWN DOWN DOWN DOWN DOWN DOWN DOWN DOWN